MinnSpas | EZHotTubParts.com

TidalFit Swim Spa Light Housing – 2″ with Gasket

$17.99

Fits: TidalFit swim spas with a 2″ light housing (TidalFit uses 2″, 3-1/2″ and 5″ housings; measure across the lens face). Replacement housing with its gasket, shipped from EZ’s own stock.

Not sure? Send us a photo and we’ll confirm it fits.

- +
⭐⭐⭐⭐⭐ 4.9/5 Google Rating
Guaranteed Safe Checkout

🚚 How fast will this ship? 59% of Artesian parts ship within 2 business days.

TidalFit Swim Spa 2″ Light Housing with Gasket

TidalFit swim spas use three light housing sizes: 2″, 3-1/2″ and 5″. This is the 2″ housing with gasket, the clear fitting that seals through the shell and holds the light. Replace it when the face is cracked, the lens has gone cloudy, or water is getting inside.

Measure straight across the lens face of the light you’re replacing before you order.

Find Your Parts: TidalFit Light Parts | All TidalFit Parts

What’s in the box

One 2″ light housing with its gasket. The bulb or LED, its cord, and any daisy-chain LED parts are not included.

Installation notes

Turn the swim spa off at the breaker. On a swim spa, lowering the water below the light can take a while, so plan for it. Remove the old housing, clean the shell where the gasket seats, install the new one so the gasket sits flat, then refill and check behind the light for drips.

Same housing, other Artesian-built spas

TidalFit is built by Artesian Spas. This same housing is also listed for: Artesian Elite | Artesian Platinum Elite | Island Spas | Tropic Seas Spas | Garden Spas | South Seas Spas

35-0028-30 350028-30 3500283 631-1060 6311060 57-850-1072 tidalfit swim spa 2 inch light housing with gasket rising dragon spa light lens housing

✅ Not Sure It Fits? Verify Before Ordering

Send a photo of the light you’re replacing with a tape measure across the lens face, plus your swim spa’s serial number sticker and model (EP or DT), and we’ll confirm the correct housing.


TidalFit 2″ Light Housing FAQs

This is the 2″ housing. Measure across the lens face of your light: about 2″ matches this part; the 3-1/2″ and 5″ sizes are different housings.

The housing is the shell fitting only; the LED behind it is a separate part. If your swim spa has a daisy-chain LED system, send a photo of the back of the light so we can confirm the housing matches before you order.

No. You get the housing and its gasket. Reuse your working bulb or LED.

Artesian part 35-0028-30, with lens maker number 631-1060.

Weight 0.9 lbs

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Shopping Cart
Scroll to Top