Gecko heat.wav 5.5kW Heater
This 240V, 5.5kW Gecko heat.wav heater is compatible with Gecko in.yE-3 and in.yE-5 spa control systems. It can also replace the 4.0kW heat.wav heater used with these systems.
The in.yE-3 and in.yE-5 use the same wafer board/PCB and heater relays. Proper operation requires using the correct wiring configuration and selecting the appropriate LL programming for the spa’s GFCI breaker size and complete equipment configuration.
- Heater output: 5.5kW
- Voltage: 240V
- Compatible systems: Gecko in.yE-3 and in.yE-5
- Gecko heater part number: 9920-101449
- Model number: Heat.WAV-XE-5.5-240-2-INC-IF-T PURC
- Artesian Spas part number: OP24-2110-40
Gecko heat.wav 5.5kW Heater FAQs
This Gecko heat.wav 5.5kW heater is compatible with Gecko in.yE-3 and in.yE-5 spa control systems. These systems may also be identified as in.YE3, IN.YE3, in.YE5 or IN.YE5. The in.yE-3 and in.yE-5 systems use the same wafer board/PCB and heater relays.
The Gecko part number printed on the heater is 9920-101449. The complete model number is Heat.WAV-XE-5.5-240-2-INC-IF-T PURC. It is also supplied through Artesian Spas under part number OP24-2110-40.
Yes. This 5.5kW heater can replace the 4.0kW heat.wav heater used with Gecko in.yE-3 and in.yE-5 systems. The control system must be wired correctly and programmed with the proper LL configuration for the spa’s GFCI breaker size and equipment configuration.
Yes. A 5.5kW heater produces more heat than a 4.0kW heater and can raise the water temperature faster. Actual heating time also depends on the spa’s water volume, starting water temperature, outdoor temperature, insulation and whether the spa cover is installed.
The LL configuration tells the Gecko control system which electrical and equipment configuration it should use. Selecting the correct LL setting for the spa’s wiring, equipment and GFCI breaker size allows the system to manage the heater and pumps within the available electrical capacity. An incorrect configuration can cause nuisance GFCI trips or prevent the equipment from operating as intended.
The required GFCI breaker size depends on the spa’s complete equipment configuration, including its pumps and other electrical components. The in.yE-3 or in.yE-5 system must be wired correctly and programmed with the appropriate LL setting for the installed GFCI breaker. Do not choose the breaker size or LL setting based only on the heater’s 5.5kW rating.
Compare your existing heater with Gecko part number 9920-101449 and model Heat.WAV-XE-5.5-240-2-INC-IF-T PURC. Also confirm 240V operation and that your spa uses a Gecko in.yE-3 or in.yE-5 control system.
Reviews
There are no reviews yet.