MinnSpas | EZHotTubParts.com

Cal Spas Circulation Pump, 1-Speed, 1-1/2″ In/Out, 48 Frame, 220V – Replacement

$196.99

Fits: Cal Spas hot tubs that use a 1-speed, 48 frame, 220 volt circulation pump with 1-1/2″ in/out. Cal Spas part PUMCIRC-48F1S220V; the pump is an LX WTC50M.

In stock and ships from our U.S. suppliers. Match the label on your old pump before ordering.

Not sure? Send us a photo of the pump label and we’ll confirm it fits.

- +
⭐⭐⭐⭐⭐ 4.9/5 Google Rating
Guaranteed Safe Checkout

Cal Spas Circulation Pump, 1-Speed, 1-1/2″ In/Out, 48 Frame, 220V – Replacement

This is the replacement circulation pump sold under Cal Spas part number PUMCIRC-48F1S220V. The circulation pump is the small pump that runs most of the day to move water through the filter and heater, separate from the jet pumps. The pump itself is the LX WTC50M, one of the most common hot tub circulation pumps, so the LX number on your old pump’s label is a reliable match.

Short-thread version: Cal Spas uses the standard short-thread LX WTC50M, the same pump as our LX WTC50M standard circulation pump. The long-thread WTC50M used on Sundance, Jacuzzi and Dimension One spas will not thread onto Cal Spas unions.

Specifications

  • Pump: LX WTC50M, standard short-thread
  • Type: circulation pump, 1-speed, continuous duty
  • Motor frame: 48 frame
  • Power: 220–240 volts, 60 Hz, about 1.0 amp
  • Plumbing: 1-1/2″ in and 1-1/2″ out
  • Cal Spas part number: PUMCIRC-48F1S220V
  • LX part number: WTC50M

How to Match Your Old Pump

  • Read the label on the old motor: frame size (48), voltage, speed (1-speed) and amps should match.
  • Check that the unions are 1-1/2″.
  • Compare the Cal Spas number on the pump or in your paperwork to the number on this page.
  • Find your spa’s parts list in the Cal Spas owner’s manual library.

Installation Notes

  • Turn off power at the breaker and confirm it’s off before you open the equipment area.
  • Close the slice valves on both sides of the pump, or drain the spa below the pump, before you loosen the unions.
  • Replace the union gaskets when you replace the pump: 1-1/2″ flat gasket 2-pack. A cracked union nut? 1-1/2″ pump split nut.
  • Wiring a 220 volt pump is a job for someone comfortable with spa electrical. When in doubt, have a technician install it.

Related: Cal Spas Circulation Pumps | Cal Spas Jet Pumps | All Cal Spas Parts | Cal Spas Owner’s Manuals

Orders over $99 ship free in the lower 48.

✅ Not Sure It Fits? Verify Before Ordering

Cal Spas circulation pumps vary by frame size, voltage, plumbing side and pump revision, even within one model year.

To help us identify the correct replacement, please send clear photos of:

  • The label on your old pump motor
  • Your spa serial number sticker
  • The pump in place, showing which side the plumbing connects

EZ Hot Tub Parts can help confirm fitment before you order and help reduce costly returns.


It fits Cal Spas hot tubs that use a 1-speed, 48 frame, 220 volt circulation pump with 1-1/2″ unions. The surest check is the label on your old pump and the Cal Spas number PUMCIRC-48F1S220V. Send us a photo and we’ll confirm it.

Yes. Cal Spas sells the LX WTC50M under its own number, PUMCIRC-48F1S220V. Cal Spas uses the standard short-thread WTC50M, so if your old pump’s label says WTC50M, this is the replacement.

Yes. It ships from our U.S. suppliers, who carry it in stock.

Common signs are a humming motor that won’t start, a loud bearing noise, a leak from the pump seal, or a flow or heater error because water isn’t moving. Check for a dirty filter and closed valves first.

Yes. Old union gaskets often leak once disturbed. The 1-1/2″ flat gasket 2-pack is linked above.

PUMCIRC-48F1S220V PUMCIRC 48F1S220V WTC50M LX WTC50M WTC50MSTD wtc50m short thread lx circulation pump cal spa circulation pump 1.5 inch 48 frame 220v cal spas circ pump

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Shopping Cart
Scroll to Top